6 – Removal/Replacement

D

CPU Module

 

 

Screws

Latch

 

 

Screws

Figure 6-1. Removing the CPU Module

9.To remove the CPU module, grasp the latch and rotate it downward to disengage the CPU module from the backplane connector. Carefully slide the CPU module out of the slot.

6.2.2

Installing the CPU Module

To install the CPU module, do the following:

1.Slide the CPU module into the slot guide until it makes contact with the backplane connector. Rotate the blade latch upward to lock the CPU module in place. Fasten the screws.

2.Reconnect the Ethernet and serial cable to the CPU module.

3.Power up the switch. Reconnect both power cords to the power supply modules.

4.Observe the Heartbeat LED. It should blink once per second. If the Heartbeat LED is showing a different blink pattern, refer to ”Heartbeat LED Blink Patterns” on page 5-1for diagnostic procedures or contact your authorized maintenance provider.

6-4

59043-03 A

Page 98
Image 98
Q-Logic 64 manual Installing the CPU Module, Removing the CPU Module