Q-Logic manual SANbox2-64 Rail Kit

D				4 – Installation
				Installing a Switch
6
				3
4				8
2
10			5	9
1
				6
	1	7	9
	Figure 4-2. SANbox2-64 Rail Kit

1.You can install the switch in a rack “fans first” or “faceplate first”. Install the brackets (1) on the front or rear corners of the switch using three 8-32 screws on each:

„For a fans-first installation, install the brackets on the front corners of the switch.

„For a faceplate-first installation, install the brackets on the rear corners of the switch.

These instructions assume a fans-first installation.

2.Install left (2) and right (3) switch rails on the switch using six 8-32 screws (4) for each. Be sure that the latch is closest to the end of the switch that will be installed first in the rack and that the latch tab (5) is pointing down.

3.Extend the rack rails (6) to fit the inner dimensions of the rack. The rail flanges on both ends fit inside the rack. Be sure that the inner rail is toward the front. Fasten the front rail flange to the rack with two 10-32 screws (7) using the upper and lower holes. Fasten the rear end of the rail to the rack with three 10-32 screws (8). For racks with square holes, use a centering washer (9) with each screw.

59043-03 A 4-5