Q-Logic 64 manual Reset Command, Config configname

D

B – Command Line Interface Reset Command

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.

Authority	Admin session
Syntax	reset
	blade [slot_number]
	config [config_name]
	factory
	port [port_number]
	security
	snmp
	switch (default)
	system
	zoning
Keywords	blade [slot_number]
	Resets the I/O or cross-connect blade that occupies the slot given by
	[slot_number]. I/O blade slot numbers are 1–4 and 6–9; cross-connect slot
	numbers are 11–12.
	config [config_name]
	Resets the configuration given by [config_name] to the factory default values for
	switch, port, alarm threshold, and zoning configuration. If [config_name] does not
	exist on the switch, a configuration with that name will be created. If you omit
	[config_name], the active configuration is reset. You must activate the
	configuration for the changes to take effect. Refer to Table B-5through Table B-8
	for switch, port, and alarm threshold configuration default values.
	factory
	Resets switch configuration, port configuration, alarm threshold configuration,
	zoning configuration, SNMP configuration, system configuration, security
	configuration, and zoning to the factory default values. The switch configuration is
	activated automatically. Refer to Table B-5through Table B-10.
	port [port_number]
	Reinitializes the port given by [port_number]. Ports are numbered beginning
	with 0.
	security
	Clears the security database and deactivates the active security set. The security
	configuration value, autosave, and fabric binding remain unchanged. Refer to
	Table B-11for security configuration default values.
	snmp
	Resets the SNMP configuration settings to the factory default values. Refer to
	Table B-9for SNMP configuration default values.

59043-03 A B-29