D

B – Command Line Interface Set Config Command

Finished configuring attributes.

This configuration must be saved (see config save command) and activated (see config activate command) before it can take effect. To discard this configuration use the config cancel command.

The following is an example of the Set Config Zoning command.

SANbox2 #> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config zoning

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list press 'q'

or 'Q'

and

the ENTER

key to

do

so.

 

FC-SW-2 AutoSave

(True

/

False)

[True]

Default Visibility

(All

/ None)

[All ]

Finished

configuring attributes.

 

This

configuration

must be

saved (see config save command) and

activated (see config activate command) before it can take effect. To discard this configuration use the config cancel command.

59043-03 A

B-53

Page 175
Image 175
Q-Logic 64 manual Following is an example of the Set Config Zoning command, This