Q-Logic 64 manual Set Port Command

D

B – Command Line Interface Set Port Command

Set Port Command

Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. This command also clears port counters.

Authority	Admin session
Syntax	set port [port_number]
	bypass [alpa]
	clear
	enable
	speed [transmission_speed]
	state [state]
Keywords	[port_number]
	Specifies the port. Ports are numbered beginning with 0.
	bypass [alpa]
	Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address
	(ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the
	keyword ALL to choose all ALPAs.
	clear
	Clears the counters on the specified port.
	enable
	Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.
	speed [transmission_speed]
	Specifies the transmission speed for the specified port. Choose one of the
	following port speed values:
	1Gb/s
	One gigabit per second.
	2Gb/s
	Two gigabits per second.
	Auto
	The port speed is automatically detected.
	state [state]
	Specifies one of the following administrative states for the specified port:
	Online
	Places the port online.
	Offline
	Places the port offline.
	Diagnostics
	Prepares the port for testing.
	Down
	Disables the port.

59043-03 A B-57