Q-Logic 64 manual Show Log Command, Keywords component

D

B – Command Line Interface Show Log Command

Show Log Command

Displays the contents of the log or the parameters used to create entries in the log. The log contains a maximum of 200 entries. When the log reaches its entry capacity, subsequent entries overwrite the existing entries, beginning with the oldest.

Authority None

Syntax show log component level options port settings

Keywords component

Displays the components currently being monitored for events.

level

Displays the event severity level needed to create an entry in the log. If the severity level occurs on a port or on a component which is not defined, no entry is made in the log.

options

Displays the options used to set the component and log level attributes.

port

Displays the ports being monitored for events. If an event occurs which is of the defined level and on a defined component, but not on a defined port, no entry is made in the log.

settings

Displays the current settings for component, level and port. This command is equivalent to executing the following commands separately: Show Log Component, Show Log Level, and Show Log Port.

Examples The following is an example of the Show Log Component command:

SANbox2 #> show log component

Current setting(s) for log component: NameServer

The following is an example of the Show Log Level command:

SANbox2 #> show log level

Current settings for log

------------------------

level Critical

59043-03 A B-81