Q-Logic 64 manual Hotswap Command

D

B – Command Line Interface Hotswap Command

Hotswap Command

This command prompts you step-by-step through the procedure to replace an I/O blade, insert an I/O blade, or remove an I/O blade while the switch is running.

Authority	Admin session
Syntax	hotswap
Notes	The Hotswap command automatically starts and ends an Admin session in the
	presence of admin authority.
	Always perform the hot swap procedure as prompted, otherwise the switch will
	become unresponsive. For example, if you install a blade in the wrong slot,
	proceed as though you no mistake had been made and follow the rest of the
	procedures. When complete, perform the operation again with the correct slot. If
	the switch becomes unresponsive, you must power cycle the switch.
	After you select an I/O blade to remove and press the Enter key, all Port Status
	LEDs will flash green to identify the selected I/O blade.
	After you install an I/O blade and press the Enter key, the Port Status LEDs will
	flash amber in sequence by port number, then the Port Status LEDs will flash
	green.
Examples	The following is an example of the Hotswap Replace command:
	SANbox2 #> hotswap
	This command will guide you through the hotswap process. If this process is not
	followed exactly, then a seamless transition cannot be guaranteed and a switch
	power cycle will be required.
	The following procedures may be performed:
	1) Replace installed IO blade
	2) Insert an IO blade
	3) Remove an IO blade
	4) Exit this process
	Which procedure above do you want to initiate? (1-4): [4] 1
	Blade	Slot
	Type	Number
	-----	------
	IO-0	1
	IO-1	2
	IO-2	3
	IO-3	4
	IO-4	6
	IO-5	7
	IO-6	8
	IO-7	9

Which IO blade (indexed by slot number) do you want

59043-03 A B-21