Q-Logic 64 manual Set Command, Syntax set

B – Command Line Interface Set Command

D

Set Command

Sets a variety of switch parameters.

Authority Admin session for all keywords except Alarm Clear, Beacon, and Pagebreak which are available without an Admin session.

Syntax set

alarm clear beacon [state]

blade [slot_number] [state] config [option]

log [option] pagebreak [state] port [option] setup [option] switch [state]

Keywords alarm clear

Clears the alarm log. This keyword is available with User authority.

beacon [state]

Enables or disables the flashing of the Port Status LEDs according to [state]. This keyword is available with User authority. [state] can be one of the following:

on

Enables the flashing beacon.

off

Disables the flashing beacon.

blade [slot_number] [state]

Temporarily changes the administrative state given by [state] for all ports on the I/O or cross-connect blade occupying the slot given by [slot_number]. The previous Set Config Switch settings are restored after a switch reset or a reactivation of a switch configuration. [slot_number] is a number in the ranges 1–4 and 6–9. [state] can be one of the following:

online

Places the I/O blade and its ports online.

offline

Places the I/O blade and its ports offline.

diagnostics

Prepares the I/O blade and its ports for testing.

down

Disables the I/O blade and its ports.

config [option]

Sets switch, blade, port, alarm threshold, and zoning configuration parameters. Refer to the ”Set Config Command” on page B-42.

B-40 59043-03 A