Q-Logic 64 manual Removal/Replacement CPU Module

6 – Removal/Replacement CPU Module

D

4)Copy Log Files

5)Remove Switch Config

6)Remake Filesystem

7)Reset Switch

8)Show Firmware Versions

9)Set Active Image Option:1

Image filename: image_file

Unpacking ’filename’, please wait...

Unpackage successful.

0)Exit

1)Image Unpack

2)Reset Network Config

3)Reset Password File

4)Copy Log Files

5)Remove Switch Config

6)Remake Filesystem

7)Reset Switch

8)Show Firmware Versions

9)Set Active Image Option:7

11.Restore switch configuration. Move to the directory that contains the configdata file that you downloaded earlier. Use FTP to upload this file from the management workstation to the switch.

ftp 10.0.0.1 User: images Password: images ftp> binary

ftp> put configdata ftp> bye

12.Open a Telnet session and enter the Config Restore command to restore the switch configuration. Refer to ”Config Command” on page B-7for more information. If you archived the configuration using SANbox Manager, you can restore the switch configuration using the SANbox Manager Restore function.

13.Observe the Heartbeat LED. It should blink once per second. If the Heartbeat LED is showing a different blink pattern, refer to ”Heartbeat LED Blink Patterns” on page 5-1for diagnostic procedures or contact your authorized maintenance provider.

14.Reconnect the Fiber Channel port cables according to their labels. Disconnect the cross-over Ethernet cable and reconnect the original Ethernet cable if there was one.

6-6 59043-03 A