Q-Logic 64 manual SANbox2 admin # set setup snmp

B – Command Line Interface Set Setup Command

D

Table B-18. System Configuration Settings (Continued)

Entry	Description
FCNetworkMask	Fibre Channel subnet mask address. The default is
	255.0.0.0.
FCGatewayAddress	Fibre Channel IP address gateway. The default is
	10.0.0.254.
AdminTimeout	Specifies the amount of time in minutes the switch
	waits before terminating an idle Admin session.
	Zero (0) disables the time out threshold. The
	default is 30, the maximum is 1440.
UserAuthentication	Enables (True) or disables (False) the enforcement
	of account names and passwords for SANbox
	Manager. The default is False.
LocalLogEnabled	Enables (True) or disables (False) the saving of log
	information on the switch. The default is True.
RemoteLogEnabled	Enables (True) or disables (False) the recording of
	the switch event log on a remote host that supports
	the syslog protocol. The default is False.
RemoteLogHostAddress	The IP address of the host that will receive the
	switch event log information if remote logging is
	enabled. The default is 10.0.0.254.

Examples The following is an example of the Set Setup SNMP command:

SANbox2 #> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current		values will follow.
Enter a new value or simply press the ENTER key to accept the			current value.
If you wish to terminate this process before reaching the end			of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency,	alert, critical, error, warning, notify, info, debug, mark
SNMPEnabled	(True / False)	[True	]
Contact	(string, max=32 chars)	[<sysContact	undefined]
Location	(string, max=32 chars)	[sysLocation	undefined]
Trap1Address	(dot-notated IP Address)	[10.20.71.15	]
Trap1Port	(decimal value)	[162	]

B-60 59043-03 A