D

B – Command Line Interface Set Command

log [option]

Specifies the type of entries to be entered in the event log. Refer to the ”Set Log Command” on page B-54.

pagebreak [state]

Specifies how much information is displayed on the screen at a time according to the value given by [state]. This keyword is available with User authority. [state] can be one of the following:

on

Limits the display of information to 20 lines at a time. The page break functions affects the following commands: Alias (List, Members), Show (Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active, List).

off

Allows continuous display of information without a break.

port [option]

Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. Refer to the ”Set Port Command” on page B-57.

setup [option]

Changes SNMP and system configuration settings. Refer to the ”Set Setup Command” on page B-58.

switch [state]

Temporarily changes the administrative state for all ports on the switch to the state given by [state]. The previous Set Config Switch settings are restored after a switch reset or a reactivation of a switch configuration. [state] can be one of the following:

online

Places all ports online

offline

Places all ports offline.

diagnostics

Prepares all ports for testing.

Examples The following examples enables and disables the beacon:

SANbox2 #> set beacon on

Command succeeded.

SANbox2 $> set beacon off

Command succeeded.

59043-03 A

B-41

Page 163
Image 163
Q-Logic 64 manual Log option, Pagebreak state, Port option, Setup option, Switch state