Q-Logic 64 manual Table B-18. System Configuration Settings

D

B – Command Line Interface Set Setup Command

Table B-17. SNMP Configuration Settings (Continued)

Entry	Description
WriteCommunity	Write community password that authorizes an SNMP agent
	to write information to the switch. This is a write-only field.
	The value on the switch and the SNMP management server
	must be the same. The default is “private”.
TrapCommunity	Trap community password that authorizes an SNMP agent
	to receive traps. This is a write-only field. The value on the
	switch and the SNMP management server must be the
	same. The default is “public”.
AuthFailureTrap	Enables (True) or disables (False) the generation of traps in
	response to trap authentication failures. The default is False.
ProxyEnabled	Enables (True) or disables (False) SNMP communication
	with other switches in the fabric. The default is True.

system

Prompts you in a line-by-line fashion to change system configuration settings. Table B-18describes the system configuration fields. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Note: Changing the IP address will terminate all Ethernet management sessions.

Table B-18. System Configuration Settings

Entry	Description
Eth0NetworkDiscovery	Ethernet boot method: 1 - Static, 2 - Bootp, 3 -
	DHCP, 4 - RARP. The default is 1 - Static.
Eth0NetworkAddress	Ethernet Internet Protocol (IP) address. The
	default is 10.0.0.1.
Eth0NetworkMask	Ethernet subnet mask address.
Eth0GatewayAddress	Ethernet IP address gateway.
FCNetworkDiscovery	Fibre Channel boot method: 1 - Static, 3 - DHCP.
	The default is 1 - Static.
FCNetworkAddress	Fibre Channel Internet Protocol (IP) address for
	the Ethernet port. The default is 0.0.0.0.

59043-03 A B-59