Q-Logic 64 manual Threshold

D

B – Command Line Interface Set Config Command

Table B-14. Set Config Switch Parameters (Continued)

Parameter	Description
PrincipalPriority	The priority used in the FC-SW-2
	principal switch selection algorithm. 1 is
	high, 255 is low. The default is 254.
ConfigDescription	The name for the configuration. The
	default is undefined.
FC-SW-2 Compliant	Propagates just the active zone set
	throughout the fabric (True, compliant)
	or the entire zoning database (False,
	non-compliant). The default is True.
LegacyAddressFormat	Available only when the FC-SW-2
	Compliant parameter is False, this
	parameter enables (True) or disables
	(False) the use of legacy address
	formatting for interoperating with
	non-FC-SW-2 switches. Refer to
	”FC-SW-2 Compliant” on page B-47.
	The default is False.

threshold

Initiates a configuration session by which to generate and log alarms for selected events. The system displays each event, its thresholds, and sampling interval one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. These parameters must be saved in a configuration and activated before they will take effect. Refer to the ”Config Command” on page B-7for information about saving and activating a configuration. Table B-15describes the Set Config Threshold parameters. The switch will down a port if an alarm condition is not cleared within three consecutive sampling intervals (by default 30 seconds). Reset the port to bring it back online. An alarm is cleared when the threshold monitoring detects that the error rate has fallen below the falling threshold.

59043-03 A B-47