1 INSTALL DIVERTER
When finished tiling the wall, remove PLASTER GUARD (1). Remove two screws that secure the DIVERTER LID (2) and remove Lid. Inspect the inside surface of diverter port.
Diverter port must be free of any dirt. Clean if necessary.
Install DIVERTER (3) with SCREWS (4) removed with DIVERTER LID (2).
Operate DIVERTER (3). DIVERTER (3) should slide in and out smoothly.
1
DIVERTER
PORT
2
3
4
2 INSTALL VALVE TRIM
Figure 1. Push CAP (1) over VALVE CARTRIDGE (2) until seated against stop. Push CAP (3) over DIVERTER (4) until seated against stop.
Figure 2. Push ESCUTCHEON HOLDER (5) onto CAP (1) and attach to valve body with SCREWS (6). Mount ESCUTCHEON SUPPORT (7) to ESCUTCHEON HOLDER (5) with SCREWS (8).
Figure 3. Install ESCUTCHEON (9) onto CAP (1) and push flush against finished wall. Escutcheon (9) will snap fit onto ESCUTCHEON SUPPORT (7).
5
7
1
6
Figure 2.
8
4
3
2
Figure 1. | 1 |
9 7 1
Figure 3.
M968836 Rev . 1 . 4
