Using Your Dialogue XL-50
Incoming Voice Volume
You can adjust the volume of incom- ing calls by simply sliding the VOL control. This gives you up to 18 dB. If you want more amplification, follow the directions below.
1.Press the AMPLIFY button as shown in Figure 8 to turn the incoming voice amplifier on or off. When AMPLIFY is on, the AMPLIFY indicator comes on.
HOLD*PROG | 0 | P |
| # |
E |
| |||
| FLASH | REDIAL | ||
TONE | AMPLIFY |
| VOL | |
|
|
| ||
LO
Figure 8 - AMPLIFY Button
and Indicator
2.Adjust the volume in the ear piece by moving the VOL slide control in Figure 9. With AMPLIFY on, incoming volume will be up to 48dB louder.
HOLD*PROG | 0 E | FLASH | REDIAL |
TONE | AMPLIFY |
| VOL |
|
| ||
LO | HI |
|
|
Figure 9 - Volume Slide Control
Caution: Repeated incremental expo- sure to amplification levels greater than 18 dB may be harmful to indi- viduals without hearing disabilities. Therefore, do not remove the warning label attached to the back of the handset. If it is likely that a visually impaired person will use the tele- phone, securely attach the provided warning printed in Braille to the back of the handset (See, Diagram A).
C A U T I O N
U S E W I T H
VOLUME
LOUD
Diagram A.
Note: In standard use, the amplifier turns off whenever you hang up the telephone. This is a useful feature if many people use the phone. If you want the amplifier to always remain on, slide the Volume Reset Override switch on the back of the phone to ON, as shown in Figure 10.
- OFF
MANUAL
AUTO- ON
Volume
Reset
Override
Figure 10 - Volume Reset Override On/Off
6
