Ameriphone DIALOGUE XL-50 Troubleshooting Chart FCC Statement, Symptom Corrective Action

Troubleshooting Chart FCC Statement

The chart below will help you solve most problems that may arise during operation of your telephone.

Should the difficulty continue, contact Ameriphone or your authorized deal- er for assistance.

	CAUSE AND
SYMPTOM	CORRECTIVE
	ACTION
No dial tone	Check all phone
	cord connections.
No number	No number stored
	in that memory
dialed when
	button. See:
memory	“Programming the
button pressed	Memory buttons”,
	P. 9.
Call cannot	See “Setting Up
	Your Phone” to
be dialed,
	reset the dial
or dials
	mode switch,
very slowly
	P. 4, 5.
An incoming	Make sure the
call does not	ringer is not set to
produce an	the OFF position.
audible ring
Phone locks-	1. Unplug the
up.	AC adapter.
	2. Remove backup
No functions
	batteries.
operate	3.Then, plug in the
	AC adapter
	and reinstall
	batteries.

The DIALOGUE XL-50 has been registered with the Federal Communications Commission (FCC) and complies with the standards in Part 68 of the FCC Rules.

FCC compliant telephone cords and modular plugs are provided with this telephone. Your telephone company is required by the FCC to allow you to connect FCC registered tele- phone equipment to their telephone lines.

The FCC requires that upon request of your local telephone company, you provide the FCC registration number and Ringer Equiva- lence Number (REN) of your telephone equip- ment, both noted on the underside of the Dialogue XL-50.

Your Dialogue XL-50 has been tested and found to meet the standards for a Class B digital device, as specified in Part 15 of the FCC Rules. These specifications are designed to provide against interference with radio and television reception in a residential installa- tion. There is no guarantee that interference will not occur in a particular installation. If your Ameriphone product causes interference with radio or television reception when in use, you might correct that interference with any one or all of these measures:

1.Where it can be done safely, reorient the receiving television or radio antenna.

2.To the extent possible, relocate the televi- sion, radio or other receiver with respect to the telephone equipment.

3.If your telephone product runs on AC power, plug it into an AC outlet that is not on the same circuit as the one used by your radio or television.

11