Special Features (continued)
Programming the Memory Buttons
You can automatically dial twelve programmed telephone numbers using the memory buttons shown in Figure 19. Each button can be programmed (or reprogrammed using the same procedure) for a phone number up to 15 digits long.
M3 |
| M9 |
M4 |
| M10 |
M5 |
| M11 |
M6 |
|
|
| ¤ |
|
1 | A | D |
2B | 3E | |
Figure 19 - Memory Buttons | ||
To program a button, follow these steps:
1.Lift the handset and press PROG as shown in Figure 20.
HOLD*PROG | 0 |
| # |
FLASH | REDIAL | ||
TONE | AMPLIFY |
| VOL |
|
| ||
LO | HI |
|
|
Figure 20 - PROG Button
2.Enter the phone number on the keypad (Figure 21) just as you would dial it normally.
Note: Press REDIAL if you want to insert a brief pause between two numbers.
1 2C 3F
G | J | M |
4HI | 5 L | 6 ON |
| K |
|
P | T | W |
7RS | 8UV | 9XY |
HOLD*PROG | O | # |
0 PE | ||
| FLASH REDIAL |
Figure 21 - Telephone Keypad
3.Press PROG (Figure 20) once again.
4.Press a memory button (Figure
19)to store this number on that button.
5.Immediately hang up the handset.
Note: Any number previously stored at that memory button will be overwritten.
6.To change a stored number, repeat the programming process starting with step 1.
11
