Installation
5
CSG SIP Communications Gateway
Understanding the LEDs
There are 14 LEDs on the front panel of the CSG. The eight LEDs corresponding to the analog ports on
the rear panel, indicate the type of interface installed. The definition of each LED and its color
representation is explained below.
Using the Configuration Reset Switch
The Configuration Reset (CFG RST) switch (rear panel - see FIG.2) resets the current configuration to
the factory defaults when pressed. The switch must be continuously pressed during the boot process.
This will force the unit to delete all configuration data.
LED Definitions
LED Color Description
Power: • Blue (pulsing) On when the unit boots up after the bootload process has
completed. The LED pulses at a rate which is proportional to the
BlackFin processor load.
Network: • Off No line is connected or the interface is inactive.
• Green (flashing) Link is up at 100Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
• Red (flashing) Link is up at 10Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
IP Phones
(4 ports):
• Off No line is connected or the interface is inactive.
• Green (flashing) Link is up at 100Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
• Red (flashing) Link is up at 10Mbps. LED flashes at 1/10 second intervals as
traffic is detected.
Analog (8 ports): • Off No analog port is installed in the corresponding port.
• Green (solid) Port is configured for FXS operation and is enabled. An analog
telephone may be connected to this port.
• Green (flashing) Telephone is ringing.
• Green (slow blinking) Telephone is in use.
• Red (solid) Port is configured for FXO operation and is enabled. A telephone
line may be connected to this port.
• Red (flashing) Telephone line is ringing.
• Red (slow blinking) Telephone line is in use.
FIG. 2 Rear panel connectors
Analog ports
IP Phones ports
Network port
Config Reset
Console port
Power