AMX DAS-MET-NUM specifications Mounting Procedures, Programming, Additional Documentation

Mounting Procedures

AMX recommends mounting Metreau keypads in standard U.S.-style decora wallboxes:

•Conduit box should meet NEC specs (section 370)

•Minimum internal clearance of (HWD) 2-5/8" x 1-3/4" x 1-5/8".

Note: Before touching the device, discharge the static electricity from your body by touching a grounded metal object.

Wallbox Mounting

1.Use the cutout dimension for the wallbox to cutout the install surface.

2.Connect the AxLink connector (or SWT cable connectors) to the rear of the keypad.

3.Place the Mounting Plate on the wallbox; align the screw holes with the mounting holes and fasten the Mounting Plate to the wallbox using the screws supplied.

Note: Do not overtighten the screws when mounting the Mounting Frame. The device should be flush with mounting surface.

Mounting Dimensions

FIG. 4 provides detailed dimensions for the 13-button Metreau keypads.

FIG. 4 Mounting Dimensions - DAS-MET-NUM

Programming

SWT-only Metreau keypads (DAS-MET-6SRC and DAS-MET-NUM) are configured via the Tango Audio Controller. Refer to the Tango Audio Controllers Operation / Reference Guide for details.

Additional Documentation

Refer to the Metreau Keypads Operation/Reference Guide (available online www.amx.com) for additional information on configuration, programming and using the Metreau keypads.

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 93-1122-02 REV: A

1/08

©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com