Omron CS1W-RPT01, CVM1-CLK21, CJ1W-CLK21-V1 Data Links Procedures, Manually Setting Data Links

Data Links Procedures Section 2-1

2-1 Data Links Procedures

2-1-1 Manually Setting Data Links

When the data link mode is set for manual data link table creation, the data link tables can be input using the Controller Link Support Software or CX-Pro- grammer. Use the following procedure.

1,2,3...	1. Install and wire the Units.
		Contents	Method	Nodes	Page
		a. Mount the Units to	---	All nodes	59
		the PLCs.
		b. Wire the Network.	---	All nodes	66

2.	Prepare for communications.
	Contents	Method	Nodes	Page
	a. Set the unit num-	Use the front rotary	CS/CJ-series, CVM1,	98
	ber.	switches.	and CV-series PLCs
			only
	b. Set the node	Use the front rotary	All nodes	94,98
	address.	switches.
	c. Set the baud rate.	Use the DIP switch.	All nodes	95, 99
	d. Set the operating	Use the DIP switch.	C200HX/HG/HE PLCs	95
	level.		only
	e. Set the terminal	Use the front switch	All nodes	96, 99
	resistance	for CVM1, CV-series,	End nodes on the net-
		CS/CJ-series, and	work: ON
		CQM1H-series PLCs
			All other nodes: OFF
		or the bottom switch
		for C200HX/HG/HE
		PLCs.
3. Turn ON the power to the PLC.
	Contents	Method	Nodes	Page
	Turn ON the power to	---	All nodes	---
	the PLC.
4. Connect the Programming Device.
	Contents	Method	Nodes	Page
	Connect the Program-	Use the special con-	CS/CJ-series, CVM1,	21
	ming Console or Con-	nection cable.	and CV-series PLCs
	troller Link Support
	Software.
5.	Create I/O tables.
	Contents	Method	Nodes	Page
	Input the I/O tables.	Use the Support Soft-	CS/CJ-series, CVM1,	---
		ware or Programming	and CV-series PLCs
		Console.	only

32