Omron CS1W-CLK21-V1, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, C200HW-CLK21 Gramming Console

Data Links Procedures Section 2-1

Note a) When using fewer than 33 nodes, make sure that the Wired Net- work 62 Node Enable Bit if the DM Parameter Area software switch is turned OFF to restrict the network to 32 nodes maximum. To construct a network containing more than 32 nodes, all nodes must use the CS1W-CLK21-V1 or CJ1W-CLK21-V1.

b)Be sure that the data link mode in the data link parameters in the DM Area is set to 00 when using manually set data links.

c)When using the 8-bit storage format, make sure that the relevant locations in the DM Parameter Area are set to 0. The storage for- mat used by all models other than CS1W-CLK21-V1, CS1W- CLK21, CJ1W-CLK21-V1, and CJ1W-CLK21 is fixed at 8-bit, re- gardless of the setting.

7.Set the parameters for automatic data link creation.

•Equality layout: Previous automatic creation method (Compatible with CS1W-CLK21-V1, CJ1W-CLK21-V1, CS1W-CLK21, CJ1W-CLK21, C200HW-CLK21, CVM1-CLK21, and CQM1H-CLK21)

	Contents		Method	Nodes	Page
a. Set the data link mode			Use the Support	Data link startup node	113
to automatic.			Software or Pro-	only
			gramming Console.	The node that is used
				to start the data link is
				called the startup
				node. It is necessary
				to decide beforehand
				which node will be
				the startup node.
Area	b.	Set the area		Data link startup node	130
1				only
	c.	Set the data
				Only when Area 1 is
		link start word
				used
	d.	Set the num-
		ber of data link
		words
Area	e.	Set the area		Data link startup node
2				only
	f.	Set the data
				Only when Area 2 is
		link start word
				used
	g.	Set the num-
		ber of data link
		words
h. Set the first data link				Data link startup node
status word				only
				(This setting may be
				omitted.)
i. Set the nodes to par-				Data link startup node
ticipate in the data				only
links.

36