Omron CQM1H-CLK21 Creating Routing Tables, Appropriate Unit according to the routing tables

Routing Tables Section 7-3

CX-Programmer

ACX-Programmer connected to a CS/CJ-series, C200HX/HG/HE, CVM1, CV-series, or CQM1H-series CPU Unit can program and monitor any other PLC on a different type of network (Ethernet, SYSMAC NET, or SYSMAC LINK) through a CS/CJ-series, CVM1, or CV-series PLC.

CX-Programmer Programming Device

Controller Link Network Controller Link Network

Programming and monitoring

CS/CJ-series, C200HX/HG/ HE, CVM1, CV-series, or CQM1H-series PLC

CS/CJ-series, CS/CJ-series PLC CVM1, or CV-

series PLC

CX-Programmer		Controller Link Network	Ethernet Network
	Controller Link
	Support Software
		C200HX/ CS/CJ-series PLC CS/CJ-series, CVM1,
		HG/HE PLC		or CV-series PLC

Note Remote programming and monitoring is possible from computer nodes.

Note 1. Version 1.20 of CX-Programmer must be used for the CQM1H-series Con- troller Link Unit.

2. Use CX-Programmer version 2.04 or higher for a CJ-series Controller Link Unit.

7-3	Routing Tables
		Routing tables that define the communications path from the Controller Link
		Unit on the local PLC to the network connected to the destination PLC must
		be created in order to send and receive data across networks. Each CPU Unit
		implements the message service or remote programming/monitoring to the
		appropriate Unit according to the routing tables.
Creating Routing Tables
		Routing tables consists of a local network table and a relay network table.
Local Network Table		A local network table provides unit numbers and network addresses corre-
		sponding to the Units mounted to the PLC.

	Unit number 04
	Unit number 05
	Unit number 06
Example	Unit number 07
	Local network table

Network address 1 Network address 2 Network address 3 Network address 4

Local network	Unit number
address
1	04
2	05
3	06
4	07

Note 1. The unit number is set between 0 and 15 using the rotary switch on the front panel of Controller Link Units for CS/CJ-series, CVM1, and CV-series PLCs, and is the same as the operating level for C200HX/HG/HE PLCs. Set operating level 0 for CQM1H-series Control Link Units.

239