Omron CJ1W-CLK21-V1, CVM1-CLK21, CS1W-RPT01 Chain Type, CS/CJ Series Word 0 of DM30000 + 100 ⋅ N

CVM1/CV Series:

CQM1H Series:

9. Stop the data links.

Data Links Procedures				Section 2-1
		Chain Type
		Contents	Method	Nodes	Page
	a.	Set the data link mode	Use Support Soft-	Data link startup node	113
		to automatic.	ware for the PLC	only
			including Program-	The node that is used
			ming Console (see	to start the data link is
			note).	called the startup
				node. It is necessary
				to decide beforehand
				which node will be
				the startup node.
	b.	1:N creation		Data link startup node	141
				only
	c.	Set the area
	d.	Set the data link start
		word
	e.	Set the number of
		common send words
		per master node
	f.	Set the number of
		send and receive
		words per node
	g.	Set the first data link
		status word
	h.	Set the nodes to par-
		ticipate in the data
		links.

Note For automatic data link creation with 1:N allocations, use the CX-Net in CX-Programmer version 3.2 or higher.

8. Start the data links.

Contents	Method	Nodes	Page
Start the data links.	Switch the Data link	Data link startup node	153
	Start/Stop Bit (listed	(The Start Bit can be
	below) from OFF to
		turned ON in more
	ON using either the
		then one node to
	Programming Device,
		make sure the data
	or the user program.
		links start even when
		the startup node is
		down.)

Note Data link Start/Stop Bit (N= unit number):

CS/CJ Series: Word 0 of DM30000 + 100 ⋅ N

C200HX/HG/HE: AR 0700 (operating level #0),

AR 0704 (operating level #1)

Word 0 of DM 2000 + 100 ⋅ N

AR 0700

Contents	Method	Nodes	Page
Stop the data links.	Switch the Data link	Any node that is active	153
	Start/Stop Bit (listed	in the data link
	below) from OFF to
	ON using either the
	Programming Device,
	or the user program.

Note Data link Start/Stop Bit (N= unit number):

CS/CJ Series: Word 0 of DM30000 + 100 ⋅ N

39