Omron CQM1H-CLK21, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, C200HW-CLK21, CS1W-CLK21-V1 317

Error Log						Section 9-3
Error	Contents	Detail code		Correction	Written to		Applicable
code					EEPROM		PLC
		1st byte	2nd byte
0109	Transmission failed; destination	Command block		Increase number of	No		All
Hex	busy	Bits 0 to 7:		retries or reconfig-
		Source node address		ure system to distrib-
		Bits 8 to 14:		ute load.
010A	Transmission failed; communica-	Source Network address		Conduct an echo-	Yes		All
Hex	tions controller error	Bit 15:		back test and if the
		OFF		effects of noise are
		Response block		considerable, recon-
		Bits 0 to 7:		sider the operating
		Destination node		environment. Restart
		address		the Controller Link
		Bits 8 to 14:		Unit. If the error
		Destination Network		occurs again,
				replace the Unit.
		address
010B	Transmission failed; PLC error	Bit 15:		Refer to the PLC	No		All
Hex		ON		operating manual. If
		(1st byte: bits 8 to 15;		the error occurs
				again, replace the
		2nd byte, bits 0 to 7)
				PLC.
010C	Transmission failed; unit number			Check unit number	No		CV, CS/CJ
Hex	incorrect			settings to be sure
				they are within range
				and unique.
010D	Transmission failed; destination			Check routing tables.	No		All
Hex	address incorrect
010E	Transmission failed; routing			Check routing tables	No		All
Hex	tables not registered
010F	Transmission failed; routing table			Check routing tables.	No		All
Hex	error
0110	Transmission failed; too many			Check routing tables	No		All
Hex	relay points			and system configu-
				ration. Use a CS/CJ-
				series CPU Unit with
				unit version 2.0 or
				later and CX-Pro-
				grammer Ver. 4.0 or
				higher to send com-
				mands across three
				or more network lev-
				els.
0111	Transmission failed; command			Be sure to use the	No		All
Hex	packet too long			FINS command
				format.
0112	Transmission failed; header			Be sure to use the	No		All
Hex	error.			correct FINS
				command format.
0113	Transmission failed; I/O setting			Check I/O table	No		CV, CS/CJ
Hex	error			accuracy.
0114	Transmission failed; CPU bus			Check Unit and cable	No		CV, CS/CJ
Hex	error			connections and
				clear error.
0115	Transmission failed; redundant I/			Check unit numbers	No		CV, CS/CJ
Hex	O allocations			for redundancy within
				the same PLC.
0116	Transmission failed; CPU Bus			Check Unit and cable	No		CV, CS/CJ
Hex	Unit error			connections and
				clear error.

317