Omron C200HW-CLK21, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1 Send/Receive Data Areas, Area Range

Introduction					Section 6-1
		Type of command		Code	CS/	CVM1/
					CJ	CV
	File Memory		FILE NAME READ	2201	Yes	Yes
			SINGLE FILE READ	2202	Yes	Yes
			SINGLE FILE WRITE	2203	Yes	Yes
			MEMORY CARD FORMAT	2204	Yes	Yes
			FILE DELETE	2205	Yes	Yes
			VOLUME LABEL CREATE/	2206	No	Yes
			DELETE
			FILE COPY	2207	Yes	Yes
			FILE NAME CHANGE	2208	Yes	Yes
			FILE DATA CHECK	2209	No	Yes
			MEMORY AREA FILE	220A	Yes	Yes
			TRANSFER
			PARAMETER AREA FILE	220B	Yes	Yes
			TRANSFER
			PROGRAM AREA FILE	220C	Yes	Yes
			TRANSFER
	Forced set/reset		FORCED SET/RESET	2301	Yes	Yes
			FORCED SET/RESET	2302	Yes	Yes
			CANCEL

For details on commands for CS/CJ-series PLCs, refer to the CS/CJ-series Programmable Controllers Instructions Reference Manual (W340). For details on commands for CVM1 and CV-series PLCs, refer to the FINS Commands Reference Manual (W227). For details on commands for C200HX/HG/HE PLCs, refer to 6-6 Commands and Responses for C200HX/HG/HE and CQM1H-series PLCs. For details on commands for Controller Link Units, refer to 6-5 Commands and Responses for Controller Link Units.

6-1-3 Send/Receive Data Areas

The data areas that can be used as operands in the SEND and RECV instruc- tions depend on the PLC, as shown in the following tables. Be sure to set the operands so that the end of the data area is not exceeded.

CS/CJ-series PLCs

Area	Range
CIO (IR etc.)	CIO 0000 to CIO 6143
Work Area (WR)	W000 to W511
Holding Area	HR000 to HR511
Auxiliary Area	AR000 to AR959 (See note 1.)
Timer	T0000 to T4095
Counter	C0000 to C4095
DM Area	DM00000 to DM32767
Extended DM Area	EM00000 to EM32767 (See note 2.)

Note 1. Writing is not possible to words A000 through A447 in the Auxiliary Area.

2.A maximum of thirteen banks can be used for Expansion DM. For details on extended DM Area and the number of banks, refer to the operation manual for the PLC model that is being used.

184