Omron CS1W-CLK21-V1 Laying Optical Cable CS1W-RPT02/03 Only, Power Supply Specifications

Wiring Section 3-3

8.Do not place any object on the power cable.

9.Check that connectors are correctly attached before using the Unit.

Power Supply Specifications

The power supply to the Repeater Unit must meet the following specifications.

Item	CS1W-RPT01	CS1W-RPT02	CS1W-RPT03
	Wire-to-Wire	Wire-to-Optical (H-	Wire-to-Optical (GI)
	Repeater Unit	PCF) Repeater Unit	Repeater Unit
Power supply volt-	24 V DC
age
Allowable power	20.4 to 26.4 V DC (24 V DC, −15% to 10%)
supply voltage
range
Current consump-	24 V DC at 60 mA	24 V DC at 60 mA	24 V DC at 70 mA
tion	max.	max.	max.
Inrush current	2.5 A max. (24 V DC with rise time 5 ms)

The following Power Supply Unit is recommended:

OMRON S82K Series

Laying Optical Cable (CS1W-RPT02/03 Only)

Optical fiber cable (H-PCF or GI) can be used to create an optical connection in part of a wired network.

CS1W-RPT02 (H-PCF)

SL1

SL1

Wired Controller		H-PCF cable		Wired Controller
Link Unit				Link Unit
		SL2		SL2
	CS1W-RPT02		CS1W-RPT02
	Repeater Unit		Repeater Unit

Note 1. Always use the specified Optical Fiber Cables.

2.The maximum distance between nodes depends on how the cable is con- nected. For details, refer to the applicable Optical Fiber Cable (H-PCF) manual.

Connection Procedure Use the following procedure to connect Optical Fiber Cables to a Unit.

1,2,3... 1. Tighten screws in the mounting brackets so that the through-holes on the terminal are on the top and bottom and then affix hexagonal nuts from the opposite side of the terminal.

2.Insert bushing to the mounting bracket and secure the Unit with screws.

3.Pass the tension member through the through-holes, and tighten the ter- minal screws to affix the tension member.

4.Affix the cable to the mounting bracket so that it is clamped by the bracket.

72