Omron CS1W-CLK21-V1, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, C200HW-CLK21, CQM1H-CLK21 318

Error Log						Section 9-3
Error	Contents	Detail code		Correction	Written to		Applicable
code					EEPROM		PLC
		1st byte	2nd byte
0117	Internal buffer full	Command block		Increase number of	No		All
Hex		Bits 0 to 7:		retries or reconfig-
		Source node address		ure system to distrib-
		Bits 8 to 14:		ute load.
0118	Illegal packet discarded	Source Network address		Check for nodes	Yes		All
Hex		Bit 15:		sending illegal
		OFF		packets.
		Response block
		Bits 0 to 7:
		Destination node
		address
		Bits 8 to 14:
		Destination Network
		address
		Bit 15:
		ON
		(1st byte: bits 8 to 15;
		2nd byte, bits 0 to 7)
0203	EEPROM error	01 Hex:	01 Hex:	For CVM1 and CV-	Yes		C200HX/HG/
Hex		Read error	Data link	series PLCs, check			HE, CV,
		02: Hex:	tables	that the PLC is not			CQM1H
		Write error	02 Hex:	protected.
			Network	Remake and set the
			parameters
				relevant data. If the
			03 Hex:
				error occurs again for
			Routing
				the CVM1 and
			tables
				CV-series, replace
				the CPU Unit and for
				the C200HX/HG/HE
				PLCs, replace the
				Controller Link Unit.
0206	Number of participating nodes	Network	Number of	Check network	No		All
Hex	decreased (local node still partic-	parameters	non-partici-	parameters, node
	ipating)	maximum	pating nodes	participation, cables,
		node		and terminating
0207	Number of participating nodes				No		All
		address		resistance.
Hex	decreased (local node not partic-
	ipating)
0208	Polling node changed	Address of	Address of	Check previous	No		All
Hex		previous	new polling	polling node.
		polling node	node
0209	Inconsistent network parameter	00 Hex	Address of	Using the Controller	Yes		All
Hex			polling node	Link Support Soft-
				ware, check network
				parameters.
020C	Time out with token	00 Hex	Error status	Check network	No		All
Hex			(See note.)	parameters, node
				participation, cables,
				and terminating
				resistance.
0210	Communications controller send	00 Hex	Error status	Replace the Control-	Yes		All
Hex	error		(See note.)	ler Link Unit.
0211	Duplicate address error	00 Hex	Local node	Reset so that each	No		All
Hex			address	node address is used
				only once within the
				same Network.
0214	Node address setting error	Not specified		Check the node	Yes		CS/CJ,
Hex				address settings and			CQM1H
				correct them.

318