Omron CS1W-CLK21-V1 Parameters Error reset code command Set to Ffff Hex, Parameters Range

Commands and Responses for C200HX/HG/HE and CQM1H-series PLCs										Section 6-6
Parameters	Year, month, date, hour, minute, second, day (command): Each specified
	value is expressed in BCD.
	The ranges for setting these items are shown in the following table.
	Parameters				Range
	Year		00 to 99 (rightmost 2 digits)
	Month		01 to 12
	Date		00 to 31
	Hour		00 to 23
	Minute		00 to 59
	Second		00 to 59
	Day: As follows:
		Value		00		01	02	03	04	05	06
		Day		Sun		Mon	Tues	Wed	Thur	Fri	Sat

6-6-14 ERROR CLEAR

Clears errors from the PLC. A normal response will be returned even if an error has not occurred.

Note The cause of the error must be removed before executing the ERROR CLEAR command or the same error will occur again after the ERROR CLEAR com- mand is executed.

Command Block

21 01 FF FF

Command Error reset

code code

Response Block

21 01

Command Response

code code

Parameters Error reset code (command): Set to FFFF (Hex).

6-6-15 FORCED SET/RESET

Forcibly sets (ON) or resets (OFF) bits/flags or releases forced set/reset sta- tus. Bits/flags that are forced ON or OFF will remain ON or OFF and cannot be written to until the forced status is released.

Note This command cannot be used to release the status of Completion Flags for timers or counters. If forced status is released and the Completion Flag is turned ON, it will be force-set; if forced status is released and the Completion Flag is turned OFF, it will be force-reset.

222