Omron C200HW-CLK21, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, CQM1H-CLK21, CS1W-CLK21-V1 232

Response Codes			Section 6-7
Main code	Sub-	Probable cause	Remedy
	code
26: Command error	01	The specified area is not protected.	The program area is not protected, so it isn’t
		This response code will be returned if	necessary to clear protection.
		an attempt is made to clear protection
		on an area that is not protected.
	02	An incorrect password has been speci-	Specify a password that is registered.
		fied.
	04	The specified area is protected.	Execute the command again after executing
			the PROGRAM AREA PROTECT CLEAR
			command for the PLC.
		To many commands at destination.	The destination has received more than 5
			commands. Either interrupt servicing or wait
			for servicing to complete before re-execut-
			ing the command.
	05	The service is being executed.	Execute the command again after the ser-
			vice has been completed or aborted.
	06	The service is not being executed.	Execute the service if necessary.
	07	Service cannot be executed from local	Execute the service from a node that is part
		node because the local node is not part	of the data links.
		of the data links.
		A buffer error has prevented returning a	Reset the board. If the error persists,
		normal response.	replace the board.
	08	Service cannot be executed because	Make the necessary settings.
		necessary settings haven’t been made.
	09	Service cannot be executed because	Check the command format of and make
		necessary settings haven’t been made	the necessary settings.
		in the command data.
	0A	The specified action or transition num-	Execute the command again using an
		ber has already been registered.	action or transition number that hasn’t been
			registered.
	0B	Cannot clear error because the cause	Eliminate the cause of the error and exe-
		of the error still exists.	cute the ERROR CLEAR command.
30: Access right error	01	The access right is held by another	Execute the command again after the
		node.	access right has been released.
		(Either a Programming Device at the	(The command can be executed after the
		other node is executing an SFC online	ACCESS RIGHT FORCED ACQUIRE or
		edit, or the other node is executing an	ACCESS RIGHT RELEASE command is
		ACCESS RIGHT ACQUIRE or	completed. Releasing the access right
		ACCESS RIGHT FORCED ACQUIRE	might affect processes in progress at the
		command.)	node that held the access right.)
40: Abort	01	Command was aborted with ABORT	---
		command.

232