Omron CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, C200HW-CLK21, CQM1H-CLK21, CS1W-CLK21-V1 229

Response Codes			Section 6-7
Main code	Sub-	Probable cause	Remedy
	code
05: Routing error	01	Destination node address is not set in	Set the destination node address in the
		the routing table.	routing table.
	02	Routing table isn’t registered.	Set the source nodes, destination nodes,
			and relay nodes in the routing table.
	03	Routing table error	Set the routing table correctly.
	04	The maximum number of relay nodes	Redesign the network or reconsider the
		was exceeded in the command.	routing table to reduce the number of relay
			nodes in the command. Use a CS/CJ-series
			CPU Unit with unit Ver. 2.0 or later with CX-
			Programmer Ver. 4.0 or later to send com-
			mands across three or more network levels.
10: Command format	01	The command is longer than the max.	Check the command format of the com-
error		permissible length.	mand and set it correctly.
	02	The command is shorter than min. per-	Check the command format of the com-
		missible length.	mand and set it correctly.
	03	The designated number of data items	Check the number of items and the data,
		differs from the actual number.	and make sure that they agree.
	04	An incorrect command format has	Check the command format of the com-
		been used.	mand and set it correctly.
	05	An incorrect header has been used.	Set the routing table correctly.
		(The local node’s relay table or relay
		node’s local network table is wrong.)
11: Parameter error	01	A correct memory area code has not	Check the command’s memory area code
		been used or Extended DM Area is not	and set the appropriate code.
		available.
	02	The access size specified in the com-	Set the correct access size for the com-
		mand is wrong, or the first address is	mand.
		an odd number.
	03	The first address is in an inaccessible	Set a first address that is in an accessible
		area.	area.
	04	The end of specified word range	Check the acceptable limits of the data area
		exceeds the acceptable range.	and set the word range within the limits.
			Check the data link tables to be sure the
			limit to link words has not been exceeded.
	06	A non-existent program no. has been	Check the program number and be sure
		specified.	that it is set correctly.
	09	The sizes of data items in the com-	Check the command data and be sure that
		mand block are wrong.	the sixes of the data items are correct.
			Check the data link tables to be sure all
			nodes in the refresh parameters are in the
			common link parameters.
	0A	The IOM break function cannot be exe-	Either abort the current IOM break function
		cuted because it is already being exe-	processing, or wait until it is completed and
		cuted.	execute the command.
			Check the data link tables for node
			addresses that have been set twice.
	0B	The response block is longer than the	Check the command format and set the
		max. permissible length.	number of items correctly.
	0C	An incorrect parameter code has been	Check the command data and reenter it cor-
		specified.	rectly.
			Check the data link table file for corruption.

229