Omron CS1W-CLK21-V1 C200HX/HG/HE, CQM1H-series PLC, Response Codes, CS/CJ-series, CVM1

Using the Message Service			Section 6-3
C200HX/HG/HE and	The results of executing SEND and RECV instructions are reflected as shown
CQM1H-series PLC	in the following table.
Response Codes
	Code	Contents	Meaning
	00 (Hex)	Normal end	Data transfer was completed successfully.
	01 (Hex)	Parameter error	SEND/RECV instruction operands are not
			within specified ranges.
	02 (Hex)	Transmission impossible	The source node is not in the network or
			the Unit was reset during execution of the
			instruction.
	03 (Hex)	Destination node error	The destination node is not in the network.
	04 (Hex)	Destination node busy	The destination node is busy and cannot
		error	receive the command.
	05 (Hex)	Response timeout	A response was not received within the
			time limit.
	06 (Hex)	Response error	The response received from the destina-
			tion node was incorrect.
	07 (Hex)	Communications control-	An error occurred in the communications
		ler error	controller.
	08 (Hex)	Setting error	The destination node address was set
			incorrectly.
	09 (Hex)	CPU Unit error	A CPU Unit error occurred in the PLC of
			the destination node.
	10 (Hex)	Routing error	Command could not be sent because of
			incorrect routing.
	11 (Hex)	Relay error	Command did not reach the destination
			node because of an error at the relay sta-
			tion.
	12 (Hex)	Source node busy error	The source node is busy and cannot send
			the command.
CS/CJ-series, CVM1, and	The results of executing SEND, RECV, and CMND instructions are reflected
CV-series Response	as one word (two bytes) of data. Instruction response codes are the same as
Codes	FINS command response codes. Response code bits 08 to 15 correspond to
	the first byte of the response code, and response code bits 00 to 07 corre-

spond to the second byte of the response code. For details, refer to 6-7 Response Codes.

192