Omron C200HW-CLK21, CVM1-CLK21, CS1W-RPT01, CJ1W-CLK21-V1, CQM1H-CLK21 Command block, Response block

Error Log						Section 9-3
Error	Contents	Detail code		Correction	Written to		Applicable
code					EEPROM		PLC
		1st byte	2nd byte
0101	Transmission failed; local node	Command block		Refer to page 276	No		All
Hex	not in Network	Bits 0 to 7:		Troubleshooting
		Source node address		Using Indicators and
		Bits 8 to 14:		place the local node
		Source Network		into Network.
0103	Transmission failed; retry count	address		Using the Controller	No		All
Hex	exceeded	Bit 15:		Link Support Soft-
		OFF		ware or FINS
		Response block		commands, run
		Bits 0 to 7:		echoback test and
		Destination node		check operating envi-
				ronment if errors
		address
				occur.
		Bits 8 to 14:
0104	Transmission failed; maximum			Reduce the number	No		All
		Destination Network
Hex	number of frames exceeded.	address		of events per com-
				munications cycle or
		Bit 15:
				increase the maxi-
		ON
				mum number of
		(1st byte: bits 8 to 15;
				network parameter
		2nd byte, bits 0 to 7)
				frames.
0105	Transmission failed; node			Refer to 4-2 CJ-	No		All
Hex	address incorrect			series Controller Link
				Unitsor 4-4 CVM1
				and CV-series Con-
				troller Link Units and
				check node address
				settings to be sure
				they are within range
				and unique.
0106	Transmission failed; redundant			Correct node	No		All
Hex	node address			addresses so that
				they are unique
				within the same
				Network.
0107	Transmission failed; destination			Refer to 9-1 Trouble-	No		All
Hex	node not in Network			shooting Using Indi-
				cators and place
				destination node into
				Network.
0108	Transmission failed; specified			Refer to 4-4 CVM1	No		All
Hex	Unit does not exist			and CV-series Con-
				troller Link Units and
				check unit address
				and unit number of
				destination.

316