Omron CJ1W-CLK21-V1, CVM1-CLK21, CS1W-RPT01, C200HW-CLK21 Apply vinyl tape or a heat-shrinking tube

Wiring Section 3-3

5.Twist firmly the portion of the signal lines that are exposed.

6.Apply vinyl tape or heat-shrinking tube to the end of the cover that was peeled in step 1.

Apply vinyl tape or a heat-shrinking tube.

7.Mount the crimp terminal onto the signal lines and the shield line. Use M3 crimp terminals.

8.Connect the signal lines and the shield line to the terminal block using the markings on the terminal block.

Shield line
Communications cable	Communications cable
from the previous node	to the next node
Communications data	Communications data
High signal	Low signal

Note a) You can change the length of the signal lines as shown in the fol- lowing diagrams to make wiring a lot easier.

Approx. 30 mm

Approx. 40 mm

Approx. 50 mm

69