Omron C200HW-CLK21, CVM1-CLK21, CS1W-RPT01 Automatically Setting Data Links, Start the data links

Data Links Procedures				Section 2-1
8. Start the data links.
	Contents		Method	Nodes		Page
	Start the data links.	Switch the Data link		Data link startup node		153
		Start/Stop Bit (listed		(The Start Bit can be
		below) from OFF to
				turned ON in more
		ON using either the
				then one node to
		Programming Device,
				make sure the data
		the user program, the
				links start even when
		Controller Link Sup-
				the startup node is
		port Software or CX-
				down.)
		Programmer.
	Note a) Data link Start/Stop Bit (N= unit number):
	CS/CJ Series:		Word 0 of DM30000 + 100 ⋅		N
	C200HX/HG/HE:		AR 0700 (operating level #0),
			AR 0704 (operating level #1)
	CVM1/CV Series:		Word 0 of DM 2000 + 100 ⋅		N
	CQM1H Series:		AR 0700

b)The data links will not start if there is an error in the data link tables in the startup node.

9.Stop the data links.

Contents	Method	Nodes	Page
Stop the data links.	Switch the Data link	Any node that is active	153
	Start/Stop Bit (listed	in the data link
	below) from OFF to
	ON using either the
	Programming Device,
	the user program, the
	Controller Link Sup-
	port Software or CX-
	Programmer.

Note Data link Start/Stop Bit (N= unit number):

CS/CJ Series: Word 0 of DM30000 + 100 ⋅ N

C200HX/HG/HE: AR 0700 (operating level #0),

AR 0704 (operating level #1)

CVM1/CV Series: Word 0 of DM 2000 + 100 ⋅ N

CQM1H Series: AR 0700

2-1-2 Automatically Setting Data Links

Data link tables can be automatically created by setting the data link mode to automatic data link table creation. Use the following procedure.

1,2,3... 1. Install and wire the Units.

Contents	Method	Nodes	Page
a. Mount the Units to	---	All nodes	59
the PLCs.
b. Wire the Network.	---	All nodes	66

34