Installation
6Mio Attaché Remote Keypad Device
Charging The Attaché with the Docking Station
The Mio Attaché can also receive power for charging from an optional Docking Station. When the battery is
charging from complete depletion, the battery does a trickle charge where it starts gradually and ramps up to
full charge.
1. Connect the terminal end of the PS4.4 power supply to the rear external power port on the Mio Attaché
Docking Station. The port on the docking station is located under the station on the back. See FIG.3 for
location.
2. Route the cable through one of the provided channels so that it comes out either the top right or top left of
the Docking Station.
3. Connect the PS4.4 AC power cord to an external power source.
4. Place the Mio Attaché into the docking station so the contacts at the front of the device are on top of the
charging contacts at the front of the docking station (shown in FIG.3). The kickstand can be in either
position when charging on the base. The charging LED on the Attaché illuminates red to indicate it is
charging and turns blue when it is done. The LED is off after completion of charge cycle. Full charge
cycle for a depleted battery is approximately 3 hours.
Low Battery Indicator
The Mio Attaché is equipped with a fail-safe known as Low Battery Indicator. When the battery charge level is
too low to sustain continuous operation, the LCD flashes, "Battery Low" and the device shuts down.
FIG. 3 Mio Attaché Docking Station (Top and Bottom view)
(Top)
Charging
Contacts
- Cable Top Right
- Cable Top Left
(Bottom)
PS4.4
Power Supply
Docking Station
rear external
power port