Installation
5
Mio Attaché Remote Keypad Device
Installation

Installing The Battery

The Mio Attaché is equipped with a lithium-ion rechargable battery. The battery is charged from a PS4.4
power supply through either a DC power jack located under the kickstand or through the optional Docking
Station.
1. Extend the kickstand on the Mio Attaché to the upright position, exposing two screws on the battery door.
Shown in FIG.2.
2. Remove the two screws holding the battery door in place.
3. Plug in the connector attached to the battery pack. The mating connector is located at one end of the
battery compartment and is "keyed" to prevent it from being plugged in the wrong way.

Charging The Attaché with the Provided Power Supply

The Mio Attaché can receive power for charging from an AMX PS4.4 power supply through a barrel-plug
connector. When the battery is charging from complete depletion, it does a trickle charge where it starts
gradually and ramps up to full charge.
1. Extend the kickstand on the Mio Attaché to the upright position, exposing an external power port, 2.1 mm
barrel-style power jack. Shown in FIG.2.
2. Connect the terminal end of the PS4.4 power supply to the external power port on the Mio Attaché.
3. Connect the PS4.4 AC power cord to an external power source. The charging LED on the Attaché
illuminates red to indicate it is charging and turns blue when it is done. The LED is off after completion
of charge cycle. Full charge cycle for a depleted battery is approximately 3 hours.
FIG. 2 Mio Attaché Bottom Components
Kickstand extended
Battery door screws
Power jack
Battery door
Programming jack
Battery pack connector