AMX RDC-PDC Connecting Dry Closures, Setting AXlink and PROlink Address Numbers, Method a

Connecting Dry Closures

Use the 8 (+ common) dry closures with a WPD8 eight-button wall panel.

Dry Closure Default Presets (Cont.)

5 Channel 5 at 100% in 1 second

1 2 3 4 5 6 7 8 COM

FIG. 5 Dry closures connection

Each contact (1 - 8) is pre- programmed with a default preset.

Refer to the AMX Lighting Control

System instruction manual for details on dry closure default presets and recording new presets.

6	Channel 6 at 100% in 1 second
7	Pack on (channels 1-6)
8	Pack off (channels 1-6

All other channels are undefined.

Setting AXlink and PROlink Address Numbers:

AXlink Address	PROlink Address
		Test

Each contact closure connection (1 - 8) is pre-programmed with a default preset. The table below shows the default presets for each contact clo- sure.

Dry Closure Default Presets

Contact Closure Default Function

1Channel 1 at 100% in 1 second

2Channel 2 at 100% in 1 second

3Channel 3 at 100% in 1 second

4Channel 4 at 100% in 1 second

Set the AXlink address number	Use the PROlink DIP switch to set
(1-255) for the RDC-DC. This	the PROlink address number for the
number must match the device	RDC-DC (1-10).
number in your Axcess program.	Pin 8 on the PROlink DIP switch is
	a test switch that turns all circuits on
	to full.

FIG. 6 Setting AXlink and PROlink address numbers.

Lighting Application Drawings

Method A

RDC-PDC/120, 3 Phase 6 dimmers, 0 switches

FIG. 7 Method A

2 RDC-PDC Control Card, Dual or Three Phase