Switch Settings
When position 6 is ON, the values of the LEDs are set by writing to a mem- ory location. The lower 8 bits of the data written to the address 0x1400 0000 set the values of the LEDs. By default, position 6 is ON. For more information refer to “LEDs and Push Buttons” on page
Boot Mode and Clock Ratio Select Switch (SW10)
The SW10 switch sets the boot mode and clock multiplier ratio. Table
Table
BOOTCFG1 Pin (Position 2) | BOOTCFG0 Pin (Position 1) | Boot Mode |
|
|
|
|
|
|
OFF | OFF | SPI slave boot |
|
|
|
OFF | ON | SPI master boot |
|
|
|
ON | OFF | Parallel flash boot (default) |
|
|
|
ON | ON | Internal boot |
|
|
|
Table
Table
CLKCFG1 (Position 4) | CLKCFG0 (Position 3) | Core to CLKIN Ratio |
|
|
|
|
|
|
OFF | OFF | 6:1 (default) |
|
|
|
OFF | ON | 32:1 |
|
|
|
ON | OFF | 16:1 |
|
|
|
ON | ON | NA |
|
|
|