The MITYFLEX ® 907 and 908 models are fixed speed general purpose pumps for dispensing fluid based on products. The 907 is housed in a case and is controlled by a simple on/off switch that activates the pump. The 908 is manufactured with a zinc plated steel bracket and six inch lead wires for convenient assembly to your OEM application.
FEATURES
1.ELECTRICAL: 115 VAC, 60HZ; OPTIONS: 24 to 240 VAC; 50Hz, 60Hz, or 50/60Hz; 12 & 24 VDC. The 907 also includes; On/Off switch; 6 foot power cord.
2.PRIMING: Unit is self‐priming and will hold vacuum when off.
3.OPERATION: Pump can run dry without damaging the motor or drive unit, however the tubing life will be reduced.
4.CONSTRUCTION: Polypropylene housing and case using stainless steel fasteners.
5.MAX. HEAD PRESSURE: Maximum working pressure 40 PSI.
6.MAX. SUCTION LIFT: 29 feet (8.8m) with H₂O.
7.RATING: AC Units‐ 100% of continuous operation at 25°C ambient; DC Units‐ 100% continuous operation at 40°C ambient.
8.FLOW RATE: .4‐987 ml/min. Depending on the tubing used. (See page 5).
9.FUSE: (907 only) Located on the exterior of the case. (See page 6 for replacement procedure and page 5 for fuse type).
INSTALLATION INSTRUCTIONS
1.POWER REQUIREMENTS: Voltage and frequency of power supply must be the same as shown on unit.
2.WIRING CONNECTIONS: All wiring and electrical connections must comply with local and national electrical codes.
3.MOUNTING: (907) Case enclosed model has rubber feet and mounting flanges. This enables it to be used on a flat surface or wall mounted. Be sure that one of the sets of vent holes has plenty of air for circulation. (908) Mounting brackets for OEM applications. Be sure there is plenty of space for air circulation. Do not allow tubing to be crimped.
4.MOUNTING LOCATION: Pump should be placed in a dry location with adequate cooling provided. The ambient temperature should not exceed 25°C for AC units or 40°C for DC units..
WARNING
This unit should not be used in outdoor or hazardous locations.
4
