PROCEDURE C
Without removing the pump cover, run the entire unit at high RPM. Pull the old tubing out from outlet port pump. Install new tube by inserting into inlet port; continue feeding tube 1/4” in at a time allowing the roller assembly to push tubing through. When tubing is half way around the race, put your finger over the inlet hole of the tube and continue to feed tubing 1/4” at a time, this should make installation easier. Continue until desired tubing extension is obtained. Run unit for about one minute.
WARNING
ANKO PRODUCTS, INC. assumes no responsibility or liability for chemical compatibility of our tubing in specific applications. ALWAYS pretest tubing in accordance with tubing manufacture’s specifications. Tubing that shows signs of swelling, embrittlement, or other deterioration should not be used.
ROLLER BRACKET ASSEMBLY INSTRUCTIONS
9
