ROLLER/TUBING SELECTION
Use the following color coded rollers with the appropriate tubing I.D. Your unit is assembled with black rollers. Red rollers are included in your tubing kit. See separate instructions for roller replacement enclosed in your tube kit.
Roller | Tubing ID | ML/Revolution |
Black | 1/4” (.250) | 3.5 |
Black | 3/16” (.187) | 2.1 |
Red | 1/8” (.125) | 0.8 |
Red | 1/16”* | 0.21 |
*The 1/16”ID tubing must be inserted into 3/16” (.187) ID X 3/8” (.375) OD tubing (sleeve) for operation in pump.
FUSE INSTALLATION (907)
(See page 4 for fuse type and page 10 for fuse ordering information)
1.Disconnect power to pump.
2.Remove four screws from case front.
3.Carefully remove case cover being sure not to pull wires apart.
4.Lay the unit on a flat surface.
5.Find fuse holder and pull apart.
6.Remove old fuse and replace with new fuse.
7.Replace case cover.
FAN ASSEMBLY
(See page 4 for replacement number)
Disconnect the power from the pump.
The fan is pressed on to the rotor shaft. On all 907 case units, the fan is pressed on with metal clip away from the motor. On all OEM 908 units, the fan is pressed on with the metal clip toward the door.
6
