Pay attention to all warning labels and instructions printed on the exterior of your Antari Bubble Machine.
Unpacking & Inspection
Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In addition to the Antari Bubble Machine, you should receive the following items:
1.This user manual.
2.Power cord and plug.
Before beginning initial setup of your Antari Bubble Machine, make sure that there is no evident damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your dealer for assistance.
Setup
Remove all packing materials from the bubble machine.
Place bubble machine on a flat surface.
Loosen the side screws and lift the housing upwards. You will see a liquid tank.
Pour bubble liquid into the liquid tank, being careful not to exceed the maximum fluid level. DO NOT OVERFILL.
When the container is full, lower the housing and tighten the screws.
IMPORTANT SAFETY NOTICE:
Ensure your bubble machine is unplugged from the mains electrical supply before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that require a screwdriver to remove. Once these are removed, the finger screws can be undone by hand (see photo above).
Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown above. Take care not to spill any of the bubble fluid inside the unit.
3
