These fans have a three-speed switch that lets you choose between quiet, performance, or maximum cooling. (See specifications below.) Connect a large 4-pin connector from the power supply to the male 4-pin connector on the fan.

Note: The default setting of the fans is Low. We recommend this speed to maximize quiet computing.

Note regarding using fan speed controllers with TriCool fans:

The minimum voltage to start the fan is 5V. We recommend setting the fan speed to High if the fan will be connected to a fan control device or to the Fan-Only connector found on some Antec power supplies. A fan-control device regulates the fan speed by varying the voltage to it. The voltage may start as low as 4.5V to 5V. Connecting a TriCool™ set on Medium or Low to a fan-control device may result in the fan not being able to start. The already lowered voltage from the fan control device will be further reduced by the TriCool circuitry below 5V.

Specifications:

Size:

 

80 x 80 x 25.4mm

 

 

Rated Voltage:

12V

 

 

 

Operating Voltage:

10.2V ~ 13.8V

 

 

 

Speed

Input

Air Flow

Static

Acoustical

Input

 

Current

 

Pressure

Noise

Power

High

0.24A

2.24 m³ / min

2.54 mm-H2O

30 dBA

2.9 W

2000 RPM

(Max.)

(79 CFM)

(0.10 inch-H2O)

 

 

Medium

0.2A

1.59 m³ / min

1.53 mm-H2O

28 dBA

2.4 W

1600 RPM

 

(56 CFM)

(0.06 inch-H2O)

 

 

Low

0.13A

1.1 m³ / min

0.92 mm-H2O

25 dBA

1.6 W

1200 RPM

 

(39 CFM)

(0.04 inch-H2O)

 

 

The Upper Air Intake

There are vents on the top panel above the PCI expansion slots and CPU area. Fresh air will flow through them into the motherboard chamber to cool the VGA card and the CPU.

Note: Do not place anything on top of the NSK1480 that will block the top air vents

The Rear Air Intake

There are vents right above the rear I/O panel and on the PCI expansion slot covers to bring in fresh air to help cool the CPU and VGA card.

CPU Air Guide

The CPU Air Guide and rear air intake work together to provide fresh air to the CPU cooler to enhance the CPU cooling. The CPU Air Guide consists of several sections that can be adjusted to best suit each individual motherboard CPU position.

The Power Supply Air Intake

There are vents on the left side of the case to bring fresh air into the power supply. Note: Please leave at least 1” (2.5cm) between the left side of the case and anything that could block airflow to the power supply. This is required so that the power supply will have sufficient cooling.

5

Page 6
Image 6
Antec NSK 1480 user manual Specifications, Upper Air Intake, Rear Air Intake, CPU Air Guide, Power Supply Air Intake