Antec P150 Cable Organizer, Cooling System, TriCool fan, Specifications, Front 92 mm Fan Mounts

3.Slide the device into the drive bay until you hear a click.

4.Mount the other devices accordingly.

5.Connect a large 4-pin connector from the power supply to the male 4-pin connector on each

of the devices.

To install a floppy or other external 3.5" device to the 5.25" to 3.5" adapter:

1.Slide the adapter out.

2.Place the drive to the adapter and fasten the drive with screws provided.

3.Find a 4-pin floppy power connector on the power supply and connect it to the male 4-pin connector on the devices.

Cable Organizer

There are six hooks (cable organizers) located at the back of you can tuck cables away to increase the airflow of the case. need to open the right side panel.

Cooling System

the hard drive cage. With them To get to the cable organizer you

The TriCool fan:

The case includes one 120mm TriCool fan installed in the rear. This fan has a three-speed switch that lets you choose between quiet, performance, or maximum cooling. (See specifications below.) The fan is installed so that the air is blowing out of the case. Connect a large 4-pin connector from the power supply to the male 4-pin connector on the fan.

Note: The minimum voltage to start the fan is 5V. We recommend setting the fan speed to High if you choose to connect the fan to a fan control device or to the Fan-Only connector found on some of Antec's power supplies. A fan-controlled device regulates the fan speed by varying the voltage supplied to it. The voltage may start as low as 4.5 V to 5V. Connecting a TriCool set on Medium or Low to a fan-control device may result in the fan not being able to start. The already lowered voltage from the fan control device will be further reduced by the TriCool circuitry below 5V.

Specifications:
Size:			120 x 120 x 25.4 mm
Rated Voltage:			DC 12V
Operating Voltage:			10.2V ~ 13.8V
	Speed	Input		Air Flow	Static	Acoustical	Input
		Current			Pressure	Noise	Power
	High	0.24A		2.24 m³/min.	2.54 mm-H2O	30 dBA	2.9 W
	2000 RPM	(Max.)		(79 CFM)	(0.10 inch-H2O)
	Medium	0.2A		1.59 m³/min.	1.53 mm-H2O	28 dBA	2.4 W
	1600 RPM			(56 CFM)	(0.06 inch-H2O)
	Low	0.13A		1.1 m³/min.	0.92 mm-H2O	25 dBA	1.6 W
	1200 RPM			(39 CFM)	(0.04 inch-H2O)

The Front 92 mm Fan Mounts

You can install two 92 mm fans to the fan cage in front of the internal 3.5" drives. These fans must be installed so that the air is blowing into the case. We recommend using Antec 92 mm TriCool fans to balance quiet performance with maximum cooling. See our web site for product information. Note: Please choose your fan speed wisely. In most cases, a medium or even low speed setting will be enough to supply adequate cooling.

8