APC AP9630 installation manual Install the Network Management Card, Restore power to the card slot

Step 2: Install the Network Management Card

The Network Management Card is sensitive to static electricity. When handling the Network Management Card, touch only the end plate while using one or more of these electrostatic-discharge devices (ESDs): wrist straps, heel straps, toe straps, or conductive shoes.

For the location of the UPS card slot, see the UPS documentation.

1.Locate the UPS card slot.

2.Use the same screws that hold the slot cover in place to secure the Network Management Card in the UPS card slot.

3.Connect a network interface cable to the 10/100Base-T network connector  on the Network Management Card.

Step 3: Restore power to the card slot

To restore power to the card slot and energize the Network Management Card, reconnect the UPS to its input power source and then turn on the UPS

Step 4: Configure the Network Management Card

See “Quick Configuration” on page 8.

Installation Manual 5