Top Panel
The following section describes the controls and indicators on the top panel.
Top Panel Controls and Indicators
The top panel controls and indicators for the C3 Power Filter are detailed in Figure 2. Each numbered callout refers to a corresponding numbered description found immediately below the picture.
1 2
3
Figure 2. C3 Front Panel Controls and Indicators
1Wiring OK Status Indicator
When lit, the receptacle the C3 is plugged into is properly wired. If it is not lit, one of three wiring problems exists in the building wiring circuit: missing ground, overloaded neutral, or reversed polarity. An electrician should be consulted to resolve the problem.
2Protection On Status Indicator
When lit, the C3 is functioning properly. If the light is off (not lit), the C3 has been hit by a surge and the protection circuitry may be damaged.
3On/Off switch
Controls power to all the outlets. APC recommends that C3 be left ON at all times. When illuminated, power is ON at all outlets.
- 4 -
