APC SUM1500RMXL2U, SMT1500 Function, Factory Default Options, Description, Low Transfer

Function Factory Default Options Description

Low Transfer	120	V:	• 97 Vac
Point	106	Vac	• 100 Vac
			• 103 Vac
			• 106 Vac
	230	V:	• 196 Vac
	208	Vac	• 200 Vac
			• 204 Vac
			• 208 Vac

Set the transfer point lower if the utility voltage is chronically low and the connected equipment can tolerate this condition.This setting may also be adjusted using the power quality setting.

Note: Use the Advanced Menus to configure this setting.

Nominal Output 120 Vac		N/A	Set the nominal output voltage of the UPS on
Voltage			battery. This is available on 230 V models
	230 Vac	208-252 Vac
			only.
Transfer	High	High, Low, Medium	Select the level of sensitivity to power events
Sensitivity			that the UPS will tolerate.
			• High: The UPS will go on battery power
			more often to provide the cleanest power
			supply to the connected equipment.
			• Low: The UPS will tolerate more
			fluctuations in power and will go on battery
			power less often.
			If the connected load is sensitive to power
			disturbances, set the sensitivity to High.
Low Battery	120 sec	Set the value in	The UPS will emit an audible alarm when the
Warning		seconds	remaining runtime has reached this level.
Date of Last	Date set at factory	Reset this date when the battery module is replaced.
Battery
Replacement
Audible Alarm	On	On/Off	The UPS will mute all audible alarms if this is
			set to Off or when the display buttons are
			pressed.
Battery Self-	On start-up and	• Never	The interval at which the UPS will execute a
Test Interval	every 14 days since • Start-up only		self-test.
Setting	the last test	• Frequency of test
		(days)
Reset to Factory No		Yes/No	Restore the UPS factory default settings.
Default

8 Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower