Installation Guide
2200/3000 Tower 100/120/230 V models
The AC input/output panels on the 2200/3000 VA tower units vary in appearance. The hardwire panels and hardwiring configurations for the 2200/3000 VA tower units are identical.
Remove the five screws that secure the PDU/IO panels to the UPS.
Save these screws for securing the I/O hardwire panels. Disconnect the PDU/IO cables as shown in the diagram.
AC Input Connector
NOTE: The input and output cables may be connected to the terminal block prior to installing the panels and the terminal block in the UPS.
Secure the hardwire input and output panels (supplied), to the UPS using four of the screws removed from the PDU/IO panels.
Install appropriate strain relief clamps
(not supplied), to the I/O panels as shown in the diagram.
Output panel | Input panel |
Secure the terminal block and label to the UPS as shown in the diagram, using two screws (supplied).
Connect input and output wires as shown in diagram. |
|
| Primary |
| Ground |
| (Green Wire) |
| Input Line1 |
| (Hot) |
| Ground |
| Input Line2 |
| (or Neutral) |
Output Line1 | Output Line2 |
(or Neutral) | |
07/2008 |
Connect the terminal block and UPS connectors as shown in diagram. |
AC Input |
Connector |
AC Input |
Connectors |
Secure the blank panel to the UPS using three screws (supplied).