Installation Guide Smart-UPS I/O Hardwire Kit
Safety Information - read these instructions before hardwiring the UPS
Wiring must be performed by qualified electrical personnel.
Adhere to all national and local electrical codes when wiring this unit.
1.Disconnect equipment connected to the UPS.
NOTE: Model 5000RM5U has four internal batteries. The two front batteries must be disconnected.
2.Press the OFF button located on the front of the UPS.
3.Disconnect batteries from the UPS.
a.Model 5000RM5U has four internal battery modules. The two front internal batteries must be disconnected.
b.Models 2200/3000XL require the disconnect of one internal battery module. The XL models may have external batteries connected to the UPS. The external batteries must be disconnected from the UPS.
c.All other units require the disconnect of one internal battery module.
4.Disconnect the UPS from utility power.
When removing the panels from the UPS, note which cable is connected to the AC input. There are two
APC Worldwide Customer Support
Customer support for this or any other APC product is available at no charge in any of the following ways:
•Refer to the APC Web site to access documents in the APC Knowledge Base and to submit customer support requests.
–www.apc.com (Corporate Headquarters)
Connect to localized APC Web sites for specific countries, each of which provides customer support information.
–www.apc.com/support/
Global support searching APC Knowledge Base and using
•Contact an APC Customer Support center by telephone or
Local,
Contact the APC representative or other distributor from whom you purchased your APC product for information on how to obtain local customer support.
Entire contents copyright 2008 American Power Conversion Corporation. All rights reserved. Reproduction in whole or in part without permission is prohibited.
APC, the APC logo, and
All other trademarks, product names, and corporate names are the property of their respective owners and are used for informational purposes only.
Package Contents
| Terminal block |
| |
| Terminal block label |
| |
| Screws for securing terminal block to UPS | ||
8 screws for securing | 2 wire nuts | 4 grounding screws | |
panels to UPS | |||
|
| ||
| Model 2200/3000 Tower 100/120/230 V |
| |
| Input and output panels |
| |
| Blank panel to cover terminal block |
| |
| Model 2200/3000XL 120/208/230 V |
| |
| Input panel |
| |
| Output panel |
| |
| Blank panel to cover terminal block |
| |
| Model 5000RM5U 208/230 V |
| |
| Input and output panels |
| |
| Blank panel to cover terminal block |
| |
7/2008 |
