Apple G3 manual Chapter

4Carefully slide the drive carrier assembly backward until it is released from the floor of the computer, then lift it out.

Gently slide the entire drive carrier assembly toward the rear of the computer and lift it completely out. Be careful not to crimp or abrade any wires that are near or under the assembly.

5Configure your new hard disk drive.

Assign the Wide Ultra2 SCSI device a unique SCSI ID number.

Check the instructions that came with the device for information on selecting its setting. Some manufacturers have World Wide Web sites that provide information on configuring drives. You can also contact an Apple-authorized dealer, who may be able to install the drive for a fee.

m If your server came with two Wide Ultra2 SCSI devices, set the SCSI ID to any number but 0, 1, or 7.

A single factory-installed drive uses SCSI ID 0; a second factory-installed drive uses SCSI ID 1; and a third factory-installed drive uses SCSI ID 2. The SCSI PCI card uses ID 7. If you select one of these numbers for a new drive, the drive will not work properly.

46 Chapter 2